KnifeDogs.com Forums

I need to post a bit more often in this forum - it's always been my favorite because of the GREAT sponsor and folks who share their knowledge.

https:...

Finished this one up. W2 nakiri, with a curly rosewood handle. It is an integral,and has a hamon, but a photographer I am not, so it doesn’t show up well. This blade is “S” ground, and super thin. The majority of the blade is only .020 thick. Spine is .093. I made my own varnish for the handle by cooking rosin and linseed oil together. I like it, but I think I’m going to make a ...

Hello All.
Looking for advice please.

While sculpting a "coke bottle" handle I accidentally ground through the end of the brass female Corby (.250 diameter head) and left a hole. Ground up some fine brass and Ca glued it in. Looks like Poo.

I only have a drill press and would like to drill them out. Yes, they are epoxied in.
The challenge for me is to s...

Hi yall,

I’m reluctantly selling my pristine, never used, batch 9 I believe, Deadlock Model B.

The handles are made from marbled carbon fiber along with all heat treated Titanium hardware. The blade is dual edge, stonewashed 20CV, and has a pristine cutting edge and blade point.

I’d like to get 2400 for this piece but I am also up to hearing offers....

Haven't made a knife in 13yrs, long story, some may know...

Anyhow getting things put back together and was thinking of getting a jig for true Scandis and to just use for obvious reasons...

There are some I saw on Amazon but look cheesy, saw an old ad here where a guy sold one that looked pro grade. Just curious if anyone could point me in the right direction,...